SARPROZ ©

Thanks for your suggestion. I am trying, ‘Height’ here mean the accumulative height, doesn’t it?

I think I made a mistake, it was the logical cores…

I am running with your suggestion, it will take quite a while, hope it works.

I know the reason, it seems SARproz does not calculate the deformation velocity if you use non-linear estimation mode(as smart 5). I rerun the APS step and the SPP step using linear estimation, now the result is obtained.

If you are right, then why the velocity was not generated after the step of SPP processing was done? I rerun the SPP step, still not result.

I rerun every single step since co-registration, though time consuming, still no result. It seems the vel.mat is not generated in the APS step. Why does it happen?

Sorry forgot to compress the file

You are quite right, I did not discern the host address is changed due to the wireless internet reconstruction in our department, now I changed to the wire internet, it works smoothly. Thoroughly thanks!

I forgot to mention, the PS numbers and connection is in the screenshot below

I crop the area smaller, which up to 5000 * 6000 pixel, but it still frozen there, since I set the DL=0, the top command shows only one eternal occupied process is by MATLAB, though somehow parallel MATLAB workers show sometime.

The graph processing has been running for up to 50000 seconds, I am playing on 4 core 16 GB RAM machine, is that…[Read more]

I use top, only one matlab process is running, as describe below:

That was strange, it has occupied only 5% of CPU

Here is the Matlab windows

Thanks for you attention, the Matlab parallel pool is still busy, but waitbar is still 0%.

Yeah, you are quite right, I reset the parameters as your recommendation, in which:

1. DL=0;
2. Linear trend

I am using a dataset mainly located in the urban area, I re-run the “Sparse Point Selection” and “Graph Creation”, but stopped at “Connection Processing”, the runtime window shows as below

In fact, I do this step in last evening, and…[Read more]