SARPROZ ©

Hi Benattou

When you update to the newest version of sarproz, download this patch:

https://www.dropbox.com/s/33y1yhazib0m3pq/s1_meta_info.p?dl=0

then run again. Notice that this patch will not solve the problem, but it will generate the error file in your folder. You should see the prompt. When you get it, send the debug mat file as prompt to…[Read more]

Hi Cecilia,

Sorry for the late reply but we are still investigating the multiple errors in your case.

Meanwhile, I will need some more files from you.

In the folder where you placed your sarproz.exe, you should be able to see multiple files with the name “lasterrorS1_yyyymmdd_yyyymmdd.mat”. Please send them all to me. You can do so either…[Read more]

@yuxiao could you help please with my error because i’m stacking, if you need any additional informations feel free to contact me. thanks

Hi Venera,
1. update your software version: it’s old. An example: selecting asymmetric ranges of values in the APS module is wrong, now the sw does not allow you anymore to choose that
2. The Auto Graph works very well in urban areas to select flower centers on the ground. However, I don’t think it’s a good choice in your case. simply use a…[Read more]

ok thanks so much. all my respect

Yuxiao will contact you to get more infos on the case.

dear periz,
still i have the same problem even though i downloaded the software

Try to see if updating the sw solves the problem (via manage version)

dear Periz,
i generated the files again by processind Get content again. thanks

You should attach this log: H:kwekwesite.log, the one you sent is empty.
And the lasterror.mat is not corresponding to the error you reported above: lasterror.mat files are overwritten if multiple errors occur. To avoid loosing them you can insert your email address in the advanced parameters: you will receive an email for each error, with log…[Read more]

you’ll find the zip file below.thanks

please zip the two files and attach the .zip file

This is either related to hardware problem (like e.g. faulty memory) or operating system problem (like e.g. swap space not accessible) or matlab installation problem. Firstly, monitor the resources you are using. Then, you may try to re-install matlab, or the whole system, or run some system/hardware checks…

So, you have ramps both on the estimated height and on the estimated velocity
this is why u see non-zeros velocity.
What I would do is the following:
firstly, check interferograms and see if they are well flattened or if they have ramps themselves. If interferograms have residual orbital ramps, then u can remove them with this function:…[Read more]

more screenshots..