paulinanino

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: Accuracy of my data #7674
    paulinanino
    Participant

      Thank you very much for your response.
      So I understand that in order to see the precision of my results I should check which are the components that constitute the coherence?
      – Is there any formula or document you could tell me about how it is calculated or exactly what terms affect it?
      I understand that my results can be affected by distortion, baseline, surface area, number of images, etc. However, I would not be able to discern which of these things the software fixes and which it does not, to understand how accurate my deformations are.
      – The things that I could say don’t affect my deformation results are topography and atmosphere because of the PSI technique, and the APS processing. Is this correct?

      Thank you,

      in reply to: APS processing doubts for my project #7427
      paulinanino
      Participant

        Thanks, your help was very useful!

        in reply to: APS processing doubts for my project #7426
        paulinanino
        Participant

          Okay! I understand much better.
          And for the non linear weighning part, what would you recommend? I understand that the lower the number of images, the more coherence is required to trust the data, so m=0.8 would be a good value when it comes to few images, is that right?

          Thanks!

        Viewing 3 posts - 1 through 3 (of 3 total)