-
paulinanino replied to the topic Accuracy of my data in the forum Sarproz Forum 12 months ago
Thank you very much for your response.
So I understand that in order to see the precision of my results I should check which are the components that constitute the coherence?
– Is there any formula or document you could tell me about how it is calculated or exactly what terms affect it?
I understand that my results can be affected by distortion,…[Read more] -
paulinanino started the topic Accuracy of my data in the forum Sarproz Forum 1 year, 1 month ago
I have 2 questions regarding the accuracy of my data.
1. I understand that to obtain the deformation precision in a particular trajectory I must occupy the “stdev” which is the standard deviation.
However, when I obtain the vertical deformation using two trajectories (ascending and descending) in the multi-sensor analysis it only gives me the…[Read more] -
paulinanino replied to the topic APS processing doubts for my project in the forum Sarproz Forum 1 year, 4 months ago
Thanks, your help was very useful!
-
paulinanino replied to the topic APS processing doubts for my project in the forum Sarproz Forum 1 year, 4 months ago
Okay! I understand much better.
And for the non linear weighning part, what would you recommend? I understand that the lower the number of images, the more coherence is required to trust the data, so m=0.8 would be a good value when it comes to few images, is that right?Thanks!
-
paulinanino started the topic APS processing doubts for my project in the forum Sarproz Forum 1 year, 4 months ago
Dear all,
I have some doubts about a project I am working on. I am using 25 interferometric images to measure deformations and in the “APS processing” stage I would like to use the filter “ampl. stab. index” > 0.8 since I have few photos, however, I get very few points especially in the area I am interested in (red rectangle in the attached…[Read more]
-
paulinanino started the topic How to remove spaces in the main directory? in the forum Sarproz Forum 1 year, 7 months ago
Hi,
I have a question, when I select the directory of an area that I chose in “Selection and Extraction” I get the following message:
The main directory contains spaces
please, remove spaces in the pathWhat should I do to solve it?
Thanks -
paulinanino joined the group sarproz-group 1 year, 7 months ago
-
paulinanino became a registered member 1 year, 7 months ago
