SARPROZ ©

Good Evening in Taiwan time, Alfredo,
Thank you so much for your answer.

I have different date for my asc and des images. but the difference is not to large. however if you had successfully selected the point manually. You must need a formula to know incident angle in each PS point right? whats way that you through to reach that incidenct…[Read more]

Good morning Yunus,
from my experience, at the moment I do the same, i.e. using the multi-sense module or external GIS-based tools to produce the maps of Vertical/EW motion with some spatial averaging.

About the time series, what I do is to apply use the same formula used to derive the maps applied to some specific points, manually.

The…[Read more]

Hi Prof
Thank you, professor, I did your instructions and the system was fixed and updated.

Thanks

1. you miss telling what is your current software version
2. check the message above and download the servaddrs.mat file (do it once more if you already tried). place it in the Sarproz folder. try connecting again. please make sure you get a message saying that the servaddrs.mat file is used. if you do not get that message, you are doing something…[Read more]

Hello Prof Periz
Where we can download last version of SARPROZ. I can not update my sarproze. when I want to update, the below err appeared.

An ERROR occurred and was saved in the file lasterror.mat, directory C:SARPROZE
The LOG FILE can be found here 09_Nov_2021_12_41_36_sarproz.log, directory C:SARPROZE
Please read carefully the document…[Read more]

Thanks Daniele, will send you an email.

Hi Markus,
sure you can generate DEMs in Sarproz. There are many ways for that, depending on the characteristics of the data you want to use. That’s one of the reasons why we did not publish a clear procedure. There are other reasons for that, but the discussion would be a bit long. You can anyway find some material online. We published papers…[Read more]

Hello periz,

Thanks for the detailed response.

When applying spatial filtering, in InSAR parameters, should be selected “Output Coherence = post-filtering”? So that this post-filtered Coherence was used on MISP module as Weights. I would appreciate it if you clarify this doubt.

Regarding AutoMISP-PRJ-Atmo.mat file, the image shows APS for 5…[Read more]

The stratification in Sarproz is estimated as the APS component correlated with the topography.
If you flag that option, Sarproz will estimate a coefficient and build a model based on the external DEM and on the estimated coefficient. That model will become part of the APS estimated and removed from interferograms.
We advise you to use it only in…[Read more]

DSF is DownSamplingFactor
Because APS is low frequency signal then the APS results will be multilooked in that factor

Hi,

1. the so-called PS approach is based on the following concept:
A. star-images graph (single master).
B. no spatial filter (full resolution images, no need to generate interferograms).
C. no weights (the phase of each image weighs the same).
In such context, in Sarproz you do not need to generate interferograms. follow the tutorials online to…[Read more]